2021 • Mast and rig pulled out of boat and all rigging removed for inspection • All running rigging replaced • Cabling, lights, and electronics checked, serviced or replaced • Hydraulic furles serviced and rebuilt by Rondal • Hydraulic halyard rams serviced • Hydraulic aft stay tensioners serviced • Hydraulic boom van serviced • Mast & boom re-installed and tuned • New Furuno radar and navigators installed • New PC screens • New cockpit resolution waterproof monitor • New B&G processor and triton • New Gyro-track compass installed • All batteries serviced and or replaced 2022 • New electric motor • Variable pitch gear box taken out, dismantled and serviced. All new • Marine gearbox “Twin Disc” taken out and rebuild, new seals & bearings. 2023 • Under water Hull sand blasted, inspected • Propeller, shaft, variable pitch system and gear box works: • Variable pitch propeller “Teignbridge” dismantled and serviced • Propeller shaft pulled out, taken to machine shop. Installed in lathe, checked for wear & torsion, cleaned. Was in perfect condition. • Propeller shaft bearings serviced. oil and water seals, both engine room side and water side, all replaced. • Propeller shaft oil bath oil replaced • Propeller shaft aft “cutlass bearing” replaced • Main engine rubber support blocks replaced (all 2 ) • Propeller shaft & main engine re-aligned. Boat sea trials showed perfect alignment. • Rudder pulled out full service • Rudder lower and upper bearings serviced • Steering system & steering quadrant serviced • New bearing Laghersmith • Zink anodes new • Brand new sails • New tender Geniuss 320 |